1. Touch Sensor (Tool Calibration)
- Place and secure the material on the clamp.
- Long-press and hold the
button (for more than 5 seconds) to run probe calibration.
- Press
button to lower the tool. Lower down the tool until it comes into contact the material (placed at the center of the clamp).
- Lower the tool by using buttons or loosening the fixing bolt of the tool with a wrench, or lift the material with your hand to make the tool and material come in contact as shown in the picture below.
- Long-press and hold
button (for more than 3 seconds) until it beeps to confirm that the setting is saved then the tool will measure the material’s height.