The spindle belt transmits the rotational force of the spindle motor to the spindle to enable fast rotation of the blades. Worn out spindle belts cause the surface to crack and slip, causing the spindle motor to fail or function properly. If the force is not transmitted properly, the spindle’s rotational speed will decrease, leading to poor engraving performance and quality. Additionally, a damaged spindle belt has the potential to cause the tool to break.

• Spindle Belt Size: 40Ø (40mm)

• Replacement Cycle: The lifespan of the spindle belt is contingent upon the conditions of use, but it should be replaced at the latest every two to three months.

Spindle Belt Replacement Method

1. Turn off the MAGIC-E4.

2. Remove the head cover by unscrewing the 8 bolts on both and back sides using a 2.5mm wrench.

3. You will see a red rubber belt attached around the head. Remove this belt then replace it with a new one.

4. Put back the head cover then screw the bolts using the wrench. Fasten the L-tool fixing bolt by turning it clockwise.

Go to the E4 Descriptions➜