Menu
To enter Menu mode, press 
button. Select a menu item using the 
and 
buttons then press 
button to enter the menu item.
| 1. Tool Change | Changes the tool. | |
| 2. Select Origin | Sets the current position to the clamp origin. | |
| 3. Spindle Setup | Set spindle functions. -Spindle rotation speed: 50 to 100% (10% increments adjusted) -Start/stop spindle rotation |
|
| 4. Calibration | 1. Touch Sensor | Adjusts touch sensor settings. |
| 2. Probe | Adjusts probe settings. | |
| 3. Pointer/Flat | Adjusts pointer/flat settings. | |
| 4. Pointer/Rotary | Adjusts pointer/rotary settings. | |
| 5. Pointer/L-Tool | Adjusts pointer/L-Tool settings. | |
| 5. Measure Z-Ref | 1. Height Only 2. Horizontal(X) Slope 3. Vertical(Y) Slope 4. Plane(XY) Slope *In rotary mode, only [1. Height Only] is enabled. |
|
| 6. Ring Inside Area Check | Sets a method for checking the inner diameter engraving area: 1. L-tool 2. Laser pointer |
|
| 7. Chuck Revolution | Rotates the rotary chuck. | |
| 8. Adjust Brightness | 1. Status LED | Adjusts status LED brightness |
| 2. Inside LED | Adjusts inside LED brightness | |
| 3. Pointer | Adjusts focus laser pointer brightness | |
| 9. Vacuum Setup | Sets the Chip collector function. -Set to automatic control. -Set the Chip collector type: Dry/wet type |
|
| 10. Tool-Pos Recording | Records your current location; set whether to activate or not. | |
| 11. Auto Zref on Repeat | Sets Auto Zref method for repetitive engraving: 1. No measurement 2. Height measurement 3. Height measurement + area check |
|
| 12. Front cover | Selects whether to use the front cover or not. ※Optional device; sold separately |
|