Redt Help Center

6. Correction

The father the laser moves away from the center, the greater the distortion occurs.
When the laser passes through the lens after passing through the scan head, the farther it moves, the more distorted the shapes become (see figure on the left).
To correct distortion, correction process is used (see figure on the right).

l3main37.png


How to calibrate correction

  1. Use a material larger than (110x110 mm). Preferably, with a size of (120x120 mm).

  1. Click Correction.

l3main38.png

  1. Read the notification on calibration process. Click Next to start calibration.

l3main39.png

  1. Enter the height of the material then click Apply. Click Mark to start marking.

l3main40.png

  1. Measure the coordinate values in each corner. Enter the sizes then click Complete to finish calibration.

l3main42.png

Be sure to measure the size from each corner (as shown below).



Go to the L3 Prime Calibration➜