Redt Help Center

Operation of the Marking Machine

MAGIC-L3 Prime performs self-diagnosis upon turning ON. During self-diagnosis, the machine checks the following in order:

1. Self-diagnose Procedures

  1. If a certain axis is detected by the sensor, it moves away from the detected area.
  2. Checks the cover sensor.
  3. Checks the z-axis sensor and returns to the origin point.
  4. Returns to the origin point.
  5. Confirmation sound and standby

If no problem is found, it goes into standby mode with a confirmation sound.


2. Marking Procedures

1. Turn on the marking machine.

l3p_78.png

※ If the machine does not turn on, check the emergency switch.


2. Run the program to connect it to the machine.
※When the machine is connected to the program, the machine’s cover automatically opens upon initialization.

install54.png


3. Place your material on the work area.

l3install19.jpg


  1. Use l3clamp16.png l3clamp17.png direction key buttons to set the laser focus.
    ※When using auto focus, also set the laser focus.

l3install20.png


5. Make your design then create a toolpath.

l3install21.png


  1. Set the laser marking option.

l3install22.png


  1. Click the Machine button to send the marking data.

l3install23.png


  1. Click Start or long-press s3keypad9.png (for more than 2 seconds) to start marking.

install34.png



Go to the L3 Prime Installation➜